Energy rules for replacement windows

Whether a replacement window has to meet your state energy code's U-factor limit, what the U-factor and the window label mean, and what the states we've read say.

Updated October 10, 2026 · 43 official sources
On this page: 4 sections
  1. 1The numbers on a window
  2. 2The model code's rule
  3. 3States where a replacement window has to meet the code
  4. 4States whose energy code doesn't reach a window replacement

Energy codes limit how much heat a new window can let through.1 Whether that limit applies to a replacement window depends on your state's code and on whether your city or county enforces it. Here's what the numbers mean and what the states we've read say.

The numbers on a window

  • U-factor How fast heat passes through the window, for each square foot and each degree of difference between inside and outside. The lower the number, the less heat gets through.2
  • Solar heat gain coefficient (SHGC): how much of the sun's heat striking the window gets into the room.2
  • The label: the energy code has a window's U-factor and SHGC tested by an accredited independent lab under the National Fenestration Rating Council's procedures, and the manufacturer labels and certifies the window. Inspectors check the ratings against the label, so keep it until any inspection is done.2

The model code's rule

The model energy code says a replacement window, including a new sash and glass in an old frame, has to meet the U-factor and SHGC limits for new windows. States adopt it and often change it.1, 3

States where a replacement window has to meet the code

State What the state's code says
Arkansas The state energy code for homes treats a window replacement as an alteration that has to meet the rules for new construction, except storm windows and glass-only replacements. Cities and counties that issue building permits must adopt it.4-5
California Replacement windows have to meet the U-factor and SHGC requirements for new homes. A job replacing 75 square feet of windows or less can instead use windows with a U-factor of 0.40 or lower and, in climate zones 2, 4 and 6 to 15, an SHGC of 0.35 or lower. In climate zone 15 the SHGC can't be above 0.23. Replacing only the glass, or only the sash in an existing frame, counts as a repair.6
Connecticut Replacement windows have to meet the limits for new windows, or an area-weighted average when several are replaced.1, 7
Delaware The state's residential energy code (the 2024 model, adopted by regulation) has a replacement window meet the limits for new windows, or an area-weighted average. State law frames the code for new homes, and counties and towns enforce it, so ask yours whether a replacement window is checked.3, 8-9
Florida The Florida Building Code's energy volume requires replacement windows to meet the limits for new windows, or an area-weighted average.10
Georgia The state energy code requires replacement windows to meet the limits for new windows.11-13
Idaho The residential energy code requires replacement windows to meet the limits for new windows, or an area-weighted average.14-15
Indiana The residential code's energy chapter requires replacement windows to meet the limits for new windows, or an area-weighted average.16-17
Louisiana The state's residential energy rules require replacement windows to meet the limits for new windows, but state enforcement is mandatory only for new construction, reconstruction, additions and extensive alterations.18-19
Maine The state energy code requires replacement windows to meet the limits for new windows, or an area-weighted average.1, 20-21
Maryland The state energy code requires replacement windows to meet the limits for new windows, or an area-weighted average.1, 22
Massachusetts The base energy code requires replacement windows to meet the limits for new windows. Towns that have adopted the stretch or specialized code use that instead.1, 23
Minnesota Replacement windows have to meet the rules for new windows, but storm windows, glass-only replacements and re-siding are exempt.24-25
New Jersey When a window, skylight or door is installed or replaced, its U-factor can't exceed the residential energy code's table.26
New York When a whole window with its sash and glass is replaced, the new window has to meet the state energy code.27
North Carolina When a whole window unit with its frame, sash and glass is replaced, the new one has to meet the energy code's U-factor and SHGC table. Replacing only the glass, only the sash, or setting an insert window into the existing frame counts as a repair.28
Ohio If all or part of an existing window is replaced, including just the sash and glass, the new unit has to meet the U-factor and SHGC limits in the Residential Code of Ohio's energy table.29
Oregon Replacement windows have to meet the code's energy chapter where it applies, even though no permit is needed.30
Virginia When an existing window or door unit is replaced, the new one has to meet the U-factor and SHGC in the state energy code's residential table, and several replacements can be averaged by area.31
Washington If all or part of a window is replaced, including just the sash and glass, the new unit has to meet the state energy code's U-factor and SHGC table, and several units can be averaged by area.32-33
Wisconsin In homes built under the state's Uniform Dwelling Code, a replacement window, including its sash and glass, has to meet the code's U-factor limits, and several can be averaged by area. Older homes are covered only where the local government has adopted the code for them, and the code doesn't apply to repairs.34-35

States whose energy code doesn't reach a window replacement

State What the state's code says
Hawaii The state energy code leaves the rules for alterations, including replacement windows, to what each county has adopted.36-37
Iowa The residential energy code doesn't cover remodeling or renovation of one- and two-family homes, so it sets no state rule for replacement windows in a house.38
Nebraska The energy code covers new homes, additions, and renovations costing more than half the building's replacement cost.39
Pennsylvania The code sets window U-factor limits of 0.30 to 0.32 for new homes, depending on climate zone, but the Uniform Construction Code doesn't reach window replacements that leave the structure and the ways out alone.40-41
South Carolina The energy standard covers new homes, additions, and renovations costing more than half the building's value within 12 months.42
Tennessee The state residential program covers new homes and additions, not window replacement.43

We haven't confirmed the rule for the other states and DC yet. Ask your local building department there, and ask the installer for the new window's U-factor and SHGC either way.

Each company on this site is listed with its phone number where it has one. You can also send a request through the request form.

Energy code rules from the International Code Council, state legislatures and code agencies, and Pacific Northwest National Laboratory, checked October 2026.

Sources (43)

  1. International Code Council: 2021 IECC, existing buildings ↑
  2. Pacific Northwest National Laboratory: window and frame replacement code compliance brief ↑
  3. International Code Council: 2024 IECC, existing buildings ↑
  4. Arkansas Secretary of State: Arkansas Register, September 2014 ↑
  5. International Code Council: 2009 IECC, chapter 1 ↑
  6. California Energy Commission ↑
  7. State of Connecticut: 2022 Connecticut State Building Code ↑
  8. Delaware Administrative Code title 7, 2101 ↑
  9. Delaware Code title 16, chapter 76 ↑
  10. International Code Council: Florida Building Code, Energy Conservation, 8th edition, chapter 5 ↑
  11. Georgia Department of Community Affairs ↑
  12. Georgia Department of Community Affairs: Georgia amendments to the IECC ↑
  13. International Code Council: 2015 IECC, existing buildings ↑
  14. IDAPA 24.39.30 ↑
  15. International Code Council: 2018 IECC, existing buildings ↑
  16. International Code Council: 2020 Indiana Residential Code, chapter 11 ↑
  17. Indiana Department of Homeland Security: rules of the Fire Prevention and Building Safety Commission ↑
  18. Louisiana Administrative Code title 17, part I, Uniform Construction Code ↑
  19. International Code Council: 2021 IRC, chapter 11 ↑
  20. Code of Maine Rules 08-003, chapter 7 ↑
  21. Code of Maine Rules 08-003, chapter 2 ↑
  22. COMAR 09.12.51.04 ↑
  23. Commonwealth of Massachusetts: 10th edition residential code, chapter 11 energy efficiency amendments ↑
  24. Minnesota Rules chapter 1322 ↑
  25. International Code Council: 2012 IECC, residential energy efficiency ↑
  26. New Jersey Administrative Code 5:23 ↑
  27. New York Department of State: 2025 Residential Code of New York State ↑
  28. North Carolina Office of State Fire Marshal ↑
  29. Ohio Administrative Code 4101:8-11-01 ↑
  30. Oregon Building Codes Division ↑
  31. Virginia General Assembly ↑
  32. Washington Administrative Code 51-51 ↑
  33. Washington Administrative Code 51-11R-50300 ↑
  34. Wisconsin Administrative Code SPS chapter 322 ↑
  35. Wisconsin Administrative Code SPS chapter 320 ↑
  36. Hawaii Department of Accounting and General Services ↑
  37. Hawaii Department of Accounting and General Services: Building Code Council rules ↑
  38. Iowa Administrative Code chapter 481-301 ↑
  39. Nebraska Revised Statutes 81-1608 to 81-1616 ↑
  40. Pennsylvania Code title 34, section 403.21 ↑
  41. Pennsylvania Code title 34, section 403.1 ↑
  42. South Carolina Code title 6, chapter 10 ↑
  43. Tennessee Secretary of State ↑

Find contractors in your county

Request a quoteSearch by ZIPContractors near you